---------------------------------------------------------------------06/19/2010
CenterlineSymbol.swp              Written by Leonard Kikstra,
                                  Copyright 2001-2007, Leonard Kikstra
                                  Downloaded from Lenny's SolidWorks Resources
                                       at http://www.lennyworks.com/solidworks
-------------------------------------------------------------------------------

This macro will create a centerline symbol at a preselected point in a 
SolidWorks drawing.

-------------------------------------------------------------------------------

DISCLAIMER:
* These macros are provided free of charge for personal use and/or reference. 
* These macros may be freely distributed, provided the original copyright 
  notices remain unchanged and intact. 
* These macro will work 32bit and 64bit versions of SolidWorks 2009 and later 
  with minimal or no modification. 
* These macros, and corresponding files, are provided as is. 
* There are no warranties, expressed or implied, that these macros will perform 
  as indicated, perform to users expectations, or complete a specific task. 
* These macros will change the current SolidWorks document. Use these macros at 
  your own risk. Back up your data before using this macro on any SolidWorks 
  document. 

-------------------------------------------------------------------------------
